All pipe runs and fittings can be summed up to make one total length, and the pressure loss calculated from this length. The advantage of the equivalent length method is that it is very simple to calculate.
At smaller pipe sizes than those at which the equivalent length was estimated the pressure drop will be under-estimated. Typically as the fittings size increase the flow coefficient (L/D ratio) decreases, thus at pipe sizes larger than those at which the fittings equivalent length was determined the pressure drop will be over-estimated. Similarly the roughness and Reynolds Number are likely to be different from the conditions under which the fitting was characterised and error will be introduced. This is rarely the case however, and as such some error is introduced in the pressure drop that results. When using an equivalent length that was determined from a fitting of a different size the method relies on the assumption that as pipe size changes the fitting size retains the same relative proportions. The most accurate way to use this method is when tabulated data is available for fittings at the given size, roughness and Reynolds Number for which the pressure drop is unknown.
Option 2 : Download CADopia (the new name for Intellicad). This option does not work for later versions of AutoCAD. Option 1 : In AutoCAD 2000 only, on the pull-down click, File > Recover and then save The stamp is removed. In theory the pressure drop through the fitting is equivalent to the pressure lost through a certain length of piping at that corresponding flow rate. There are two elegant ways I have discovered to remove the educational stamp from AutoCAD. The equivalent length method (L/D ratio) allows the user to describe the pressure drop through a fitting as a length of pipe.